Stamps Mr Ma's fixture - use this tool to correct positioning your stamping tool

A common frustration I heard rubber seals in a stamping tool class is "I screwed up - I printed images are bending." A simple solution to this problem is to use the stamps Mr Ma's fixture, a tool for stamping image where you want the exact position.

Stamps Mr Ma's fixture has 2 pieces - t-shaped positioning tools and a clear, plastic, square tablet. The t type tool to have prevent slippery bottom. The vertical line length, lateral.

This process is very simple. First you stamp image in a plastic film. And then you put the table in your project, said a card or scrapbook page, and makes the image look, you want the final stamps are. Then stamp image, the exact location. Here are the details.

The clear, plastic square in your work surface. Avoid setting tool, such a corner by T is hit one of the top corner of the plastic film. I'm right-handed, so I put the tools in the upper left corner of the plastic film. Left-hand die will put it in the top right corner. Ink stamps and hold it higher than single, to the corner t. Be careful sliding straight stamps, and the stamps image in the sheet. It doesn't matter how the image of darkness, as long as you can see it.

Lying in the project of plastic film you against. Move it, makes the image in where you want the final position of the postage image postage. As before, to avoid the positioning tool, so it is hit the corner of the clear table. If table action, then start this step again and again. This is important will locate tools, not disturbed the plastic film. Now, carefully delete list, no mobile positioning tool. The tool should be part of the surface of the affix one's seal, keep in position. Just as you did before table casters clear sheet, stamps image, through the sliding stamps along the corner of the positioning tool.